Hi All, I have downloaded the Erom upgrade tool and the relevant abs file and have got the correct responses from the Erom prog. I run the Erom upgrade and burn the file and all seems to be ok but the box is still in the load loop. It gets to L100 and box display goes blank and then starts the load sequence again. I would appreciate any advice at all.
If you don't see the word DONE after connection then check your com ports---you may be on wrong one.
If box looping or just loading try a different psu before you try a reflash.
Reaper.
I would just like to post a MASSIVE thank you to 'The Reaper', for his genuine offer actually being genunie.
This day and age its difficult to find honesty and trustworthyness but its comforting to know there are still a few honest people out there. The confirmations of receipt and posting were better than most companies that have a paid for service!!
Thank you to the Reaper for not only having the knowledge but for taking the time and effort to share it too!! #Abigfan #therereallyisonlyonereaper
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.