What's new
By:
Filters

Starview HD combo + Lan how to enter C lines

drbessco

drbessco

Member
when you recive your c:line it will look like this

C: asatuk1.defghs.tv 1000 aBCd112 Efghh0

you need to split it in to 4 parts

ie - (asatuk1.defghs.tv / 1000 / aBCd112 / Efghh0)

you enter it like this on the server setup screen

NAME OR IP = asatuk1.defghs.tv

PORT = 1000

ID = aBCd112

PASSWORD = Efghh0

here's how to do it using the Carling+0712 image

Goto - menu - Accessory - network - server - 01 - press left for ON

then enter the code as above

make sure you copy the code just as it is typed
some letters are higher case and some lower case

dont forget to press apply or you will have to start again

do this for all the lines you recive

this is a dummy C:Line so dont try to use it
 
hello...thanks for the tip ....but I am very new to this and I don't even know where/how to start to get my problem (freezing) sorted as i'm scared I might just messup the whole thing and lose everything! any simple instructions (like menu map etc) would really be appreciated! thanks in advance
 
1: Get the file in downloads Starview HD Combo with lan. At time of post, latest Carling file is Carling+_F531_1207.UAD

2: Flashing your box. Put your Carling file onto a USB stick and plug in to usb behind front flap. On your HD combo go to menu, Utility and do a Factory reset. Now browse to Accessory - USB, select your carling file and click ok. Select S/W + All data update and let it install. (do not unplug while updating)

3: Setting up the cardsharing server
Make sure your box is connected to your router; there are also wireless adapters for the Starview if your network cable is to short or router is in another room.
Go to Menu - Accessory - Network - Press ok then go to Type now you will see 4 more sections in the menu, go to Server setup and press OK You will see 10 different Servers in here, Go to and select off 1 and press ok in the menu it will say off, if you highlight OFF and go to the right on the remote you can pick CCCAM or NEWCAMD in the menu. This is where you can setup your cardshare server.

Input 1 line at a time when done press exit then save is highlighted then hit ok.
Do same on all lines and when all lines complete click apply at bottom of screen;)
 
if the guy only give you one line thats ok put the one cline in 10 is if you have multiple clines
 
Last edited:
can sum 1 send me the new firmware for the starview combo + pls .and how to set up on sat as i am new to this please help
 
You must log in or register to reply here.
Back
Top