Vu+ Zero OpenATV 7.6 – OSCam not found will not start

i run this line wget -qO- --no-check-certificate "http://updates.mynonpublic.com/oea/feed" | bash in putty and i got the msg secret feed) succesfully installed but in there is none softcam manger under the blue button as well as Decryption and Parental control
Do you have softcams to download now on the green button plugin panel ?

If you do install Oscam from there and the softcam manger under the blue button as well as Decryption and Parental control will appear.
 
Do you have softcams to download now on the green button plugin panel ?

If you do install Oscam from there and the softcam manger under the blue button as well as Decryption and Parental control will appear.
no i not have i innstalled enigma2-softcams-oscam-all-images_11517-aarch64-arm-mips_all.ipk via file zilla and i innstaled via tmp in the box
 
no i not have i innstalled enigma2-softcams-oscam-all-images_11517-aarch64-arm-mips_all.ipk via file zilla and i innstaled via tmp in the box
Well download one from the plugin menu and softcam control will then appear.

Your device is the Zero 4K then
 
Last edited:
Thank you very much for your help. Regarding 7.6 it is not heavier in processing than 7.3 on old vuplus zero
 
This is specifc to ATV.
Installing the softcam feed just installs the softcam feed. After you install the softcam feed, you have to install the softcams from the plugin server. If you are installing by remote and don't see them, you have to restart the receiver.

Best to just do everything by command line. I have listed master/trunk as the versions of ATV have different names

Code:
wget -qO- --no-check-certificate "http://updates.mynonpublic.com/oea/feed" | bash
opkg update
opkg install enigma2-plugin-softcams-oscam-emu
opkg install enigma2-plugin-softcams-oscam-master
opkg install enigma2-plugin-softcams-oscam-trunk
 
Last edited:
For those of you with no experience of Telnet. The below is how to install the sofcam feed and a softcam with just a USB stick.

Download the attached softcam feed, use winrar to extract it and transfer the file to a Fat32 usb stick.

Insert the USB stick into your receiver.

You'll get a popup asking you to mount your USB select Temporary Mount as Media/USB press ok then exit button once.

You will now see the softcam feed file to install. Select it and press the green button on your remote to install the softcam feed.

If you exited too far then go to Menu-setup-software management-install local extension-Select the sofcam feed file and press the green button on your remote to install the softcam feed

Reboot your box.

Now to install your softcam.

Press the green button on your remote twice.

Scroll to the Softcam options, select your softcam of choice making sure it is highlighted and press the green button on your remote to install.

Reboot your box.

You can now see if the install went well 2 ways.

1st way blue button then softcam.

2nd way Menu-Decryption + Parental-Softcam Settings

You will now have to give the image a password so you can FTP configs over.

If you have installed oscam-emu on openATV the location is /etc/tuxbox/config/oscam-emu/
 

Attachments

Back
Top