WooshBuild Wooshbuild EPG population/refresh issue

bathbadger

Registered
Morning all. Currently running Wooshbuild Infinity, Open ATV 6.4 on Zgemma H2S. for the last 2 days I have noticed a few channels in the EPG no longer populate or refresh (Please see screen grab). They sometimes bring through some data when clicked on, but not always. Has only been happening last couple of days. I have not run any modifications or changed settings. I have also reflashed twice to see if a fresh install might clear things out, but no luck. Can't work out what the issue might be, any advice welcome. TIA
IMG_8026.jpg
 

Toddy2

TK Veteran
Forum Supporter
Morning all. Currently running Wooshbuild Infinity, Open ATV 6.4 on Zgemma H2S. for the last 2 days I have noticed a few channels in the EPG no longer populate or refresh (Please see screen grab). They sometimes bring through some data when clicked on, but not always. Has only been happening last couple of days. I have not run any modifications or changed settings. I have also reflashed twice to see if a fresh install might clear things out, but no luck. Can't work out what the issue might be, any advice welcome. TIA
View attachment 50356
Try going into EPG settings importer and enable the scan bit, then press blue for sources and tick all the relevant boxes sky etc, green to save then back in press yellow and run!
 

bathbadger

Registered
Try going into EPG settings importer and enable the scan bit, then press blue for sources and tick all the relevant boxes sky etc, green to save then back in press yellow and run!

Thanks I had already checked that, but only have the options in the screenshots below. Thought there would be more? Is there a way of bringing in more sources?

IMG_8031.jpg
IMG_8030.jpg
 

Toddy2

TK Veteran
Forum Supporter
Thanks I had already checked that, but only have the options in the screenshots below. Thought there would be more? Is there a way of bringing in more sources?

View attachment 50358
View attachment 50359
You should have more! Go into ABM and check through providers tick off what you want Sky etc configure and then scan, after that check back on EPG settings like I said in previous post and try again!
Your IPTV must be importing EPG?
 

bathbadger

Registered
You should have more! Go into ABM and check through providers tick off what you want Sky etc configure and then scan, after that check back on EPG settings like I said in previous post and try again!
Your IPTV must be importing EPG?
Already set to Sky, scanned and no change. I have done this also when i did the reflash twice.

IMG_8032.jpg
 

Toddy2

TK Veteran
Forum Supporter
Already set to Sky, scanned and no change. I have done this also when i did the reflash twice.

View attachment 50363
That looks ok, I'm on Openvix so slightly different! I think yo need HD on region! On the main bouquet I have yes FTA hd only
On configure set up I have yes to two things keep all non ABM bouquet and skip service on non configured stats, place bouquets at top!
 

makido

VIP Member
Forum Supporter
Wooshbuild installs EPG on setup so all the settings are installed
I am on 6.3 with Infinity and no problems with EPG
 
Top