Hi peeps 1st post on the forum looking for some assistance.
I've had my zgemma for little over 7 mths now.. was working fine up until 6 mths. Lost all satellite channels while watching tv and after alot of tooling and frowing I gave up so I ended up purchasing a new code recently. I also installed wooshbuild as thought it could be the old build causing problems. In last few days I have set up box with new build and new code and still wasn't working fully.. left it on overnight and channels appeared.. now watching tv have lost channels again and am now being faced with a message I have never seen before (which I hopefully have attached)
Can anybody please gI've any insight of what the problem could be whether it is hardware, software, etc
Many thanx
I've had my zgemma for little over 7 mths now.. was working fine up until 6 mths. Lost all satellite channels while watching tv and after alot of tooling and frowing I gave up so I ended up purchasing a new code recently. I also installed wooshbuild as thought it could be the old build causing problems. In last few days I have set up box with new build and new code and still wasn't working fully.. left it on overnight and channels appeared.. now watching tv have lost channels again and am now being faced with a message I have never seen before (which I hopefully have attached)
Can anybody please gI've any insight of what the problem could be whether it is hardware, software, etc
Many thanx