Hi
Hoping someone can help.
For some time now since updating to wooshbuild v5, the Zgemma regularly goes into deep standby and will not respond to the remote so a hard reboot on the rear switch is required.
I have it linked to a Kodi box in another room which I use more than the Zgemma itself. I know when the issue arises as on the Kodi box I get messages of PVR Timer deletions and then the picture will freeze. The box is still linked as I don't get the connection lost message on the Kodi box. When I go and check the Zgemma the red light is on and will not respond to the remote. Prior to this the box will most likely have been in normal standby.
Once hard rebooted then everything is fine for a while.
I think this has only happened once updated to v5.
I'd be grateful for any suggestions
Cheers
Hoping someone can help.
For some time now since updating to wooshbuild v5, the Zgemma regularly goes into deep standby and will not respond to the remote so a hard reboot on the rear switch is required.
I have it linked to a Kodi box in another room which I use more than the Zgemma itself. I know when the issue arises as on the Kodi box I get messages of PVR Timer deletions and then the picture will freeze. The box is still linked as I don't get the connection lost message on the Kodi box. When I go and check the Zgemma the red light is on and will not respond to the remote. Prior to this the box will most likely have been in normal standby.
Once hard rebooted then everything is fine for a while.
I think this has only happened once updated to v5.
I'd be grateful for any suggestions
Cheers