Fattony Newbie Dec 9, 2016 #1 Hi, Most probably being stupid, but I can TELNET with PUTTY into my box, but can't open OPENWEBIF in a browser. Any suggestions would be helpful. And thanks in advance. Cheers
Hi, Most probably being stupid, but I can TELNET with PUTTY into my box, but can't open OPENWEBIF in a browser. Any suggestions would be helpful. And thanks in advance. Cheers
dsayers2014 VIP Member Dec 9, 2016 #2 image? openvix have changed how openwebif works you now need to install it rather than it being on by default
image? openvix have changed how openwebif works you now need to install it rather than it being on by default
Fattony Newbie Dec 9, 2016 #3 dsayers2014 said: image? openvix have changed how openwebif works you now need to install it rather than it being on by default Click to expand... Using Wooshbuild, would I be better removing Openwebif and then reinstalling? Cheers
dsayers2014 said: image? openvix have changed how openwebif works you now need to install it rather than it being on by default Click to expand... Using Wooshbuild, would I be better removing Openwebif and then reinstalling? Cheers
dsayers2014 VIP Member Dec 9, 2016 #4 No should be fine on wooshbuild. Are you sure the ip address is correct Sent from my SM-G925F using Tapatalk
No should be fine on wooshbuild. Are you sure the ip address is correct Sent from my SM-G925F using Tapatalk
Fattony Newbie Dec 9, 2016 #5 I can access via Putty so it should not be different Sent from my iPad using Tapatalk
grog68 VIP Member TK Supporter Dec 9, 2016 #8 Press the green button on your remote and select OpenWebif. Make sure its enabled and on port 00080