Techkings

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Control zgemma h2s no remote

joespecs

Registered
Hey folks,

Been a while since I have been on here. Recently came across my old zgemma h2s box and was going to use it for iptv. I booted up and works a treat. Unfortunately it is stuck om UTV, tried to tuen over but the remote wouldn't work. I tried changing the batteries and also holding buttons down for 3 sec but no joy. I ordered a new remote of amazon

Original Zgemma Remote Control for Star S / 2S / H1: Amazon.co.uk: Electronics

Put new batteries and same thing with the remote.

Any ideas if there is another way to control the box to setup iptv or the box as good as dead?

Thanks in advance
Joe
 

moshibeth

TK Veteran
Hey folks,

Been a while since I have been on here. Recently came across my old zgemma h2s box and was going to use it for iptv. I booted up and works a treat. Unfortunately it is stuck om UTV, tried to tuen over but the remote wouldn't work. I tried changing the batteries and also holding buttons down for 3 sec but no joy. I ordered a new remote of amazon

Original Zgemma Remote Control for Star S / 2S / H1: Amazon.co.uk: Electronics

Put new batteries and same thing with the remote.

Any ideas if there is another way to control the box to setup iptv or the box as good as dead?

Thanks in advance
Joe
Easy way around this is to type the box ip address into google browser and it will connect to openwebif. On the left you will see a duel arrow icon above the number 3. Click on it and it will give you a remote looking icon and will allow you to use it as a normal remote control. Try changing a few functions and if no joy reflash your box with grogbuild and try.
 

joespecs

Registered
Easy way around this is to type the box ip address into google browser and it will connect to openwebif. On the left you will see a duel arrow icon above the number 3. Click on it and it will give you a remote looking icon and will allow you to use it as a normal remote control. Try changing a few functions and if no joy reflash your box with grogbuild and try.
How can I get the ip off it if no remote to check its menu settings?
 

bazcfc1

VIP Member
Forum Supporter
Go down to all builds and select it and grog free range in there along with wooshbuild ect
 
Top