What's new
By:

Install motor onto existing zone 2 pole mount?

Yes I'm happy to go with 18" t&k's. Indeed the motor will extend the offset of the dish to the required length.

Would U bolts be better than V bolts, as recommended by linesman66?

Is 2.5" x 3/8" also the correct size bolt for a 2" diameter pole? I guess I'll also need to buy some nuts too.
 
You will have the distance off the polar mount Then the motor arm is positioned
at 30° The satellite dish is positioned at the
end of the motor arm
 
Re check it was 2inch v bolts i used
Which left 1/4 thread
 

Attachments

  • 20210506_184759.jpg
    20210506_184759.jpg
    1.8 MB · Views: 9
Use 12plugs and 13mm 17mm coach bolts
Incase part of the wall isn't good To fix your
T.k set The toggle bolts can spin in the wall
If they dont catch correctly
 
The coach bolts / screws I have are M8 x 50mm with M10 x 50mm plugs. Would it be advisible to use beefier ones than this?
 
You must log in or register to reply here.
Back
Top