mag 256 firmware update

jensen62

Newbie
hi has anybody updated there mag box to image version 2.20.04-256 DATED wed 31 jan 2018
is so? what are the improvements? cant seem to find any info on the update.
thanks for any response.
 
Actually did anybody completed successfully the update? For me it stucks at 5% during "Erasing flash section".
 
hi mate yes i got that 5% update screen, i just unplugged the box for a few seconds and plugged it back in and went to the inner portal and tried again.
hope that helps?
 
Yes since i have enabled autoupdate. Actually worked on 6th plug-unplug try, but now is stuck on 100% saying "Update finished ok" but no reboot
 
Same here mag 256 did two updates on second update goes to reboot then crashes on boot up
surely customer support must no confused.
image.jpg Then on second update this
image.jpg
 
My 1st attempt got stuck at 5% and after powering off and on now stuck at 100% after 2nd attempt at update and wont reboot
 
Back
Top