I assume you are referring to an IDE drive on a dual ribbon cable?
All IDE drives carry a diagram indentifying the correct pin\jumper configuration for slave, master, CS Etc.
Are you saying yours was removed or was never there? What make model drive is it?
You don't have many options to try (Normally four positions or a fifth were the jumper is removed altogether) so you can just try the four available positions with the drive connected to the second connector on the ribbon cable until it is seen in the drive management console, it won't damage the drive if you get it wrong ;)
[video=youtube;Ds1-JmbhGRM]http://www.youtube.com/watch?v=Ds1-JmbhGRM[/video]