Script/command for Factory Reset?

[tommie]

Hi all, is there a script or command to do a factory reset?
Can only access box via DCC or Putty

 

[moshibeth]

There is what is the problem with the box ?

 

[tommie]

Also getting a `no space left on device` when i try to flash via webif, DCC etc ?

 

[moshibeth]

Also getting a `no space left on device` when i try to flash via webif, DCC etc ?

Same old problem time and time again with these h9 boxes. People never use a usb or memory card to expand the memory and box goes into loop mode and crashes. Easier to just reflash it but once done make sure you initialize a usb or you will get the same again.

 

[tommie]

Yes understood on the memory.... Info now gives Flash at 0 mbytes

but Flashing is now the problem

Box was running fine (my fault) i went to the `update software` thats when the box turned off as it started to download (suppose it filled up the memory?)

Woosh or Grog only goes so far, then this message


Help?!!

 

[moshibeth]

Yes understood on the memory.... Info now gives Flash at 0 mbytes

but Flashing is now the problem

Box was running fine (my fault) i went to the `update software` thats when the box turned off as it started to download (suppose it filled up the memory?)

Woosh or Grog only goes so far, then this message


Help?!!

Tiny memory on them and that is what has happened. Reflash it from usb now with 6.4 atv then initialize the usb to expand the memory and run grog. Woosh is no longer supported so leave that alone.

 

[moshibeth]

Make sure you leave the usb in there all the time after its done