Hi, firstly id like to say great site with loads of info!!
I have set up my zgemma H.2S with the great Kidda Setup guide. I have all of it working apart from my Nline. I installed MGCamd-1.38 with the instructions in the guide but cannot see the channels. BBC1 etc are fine
I only received a line of copy for the line. e.g CWS =(Deleted copy) 01 02 03 04 05 06 07 08 09 10 11 12 13 14
I put it into the newcamd.list file as follows;
CWS_KEEPALIVE = 300
CWS_INCOMING_PORT = 21000
CWS = (Deleted copy) 01 02 03 04 05 06 07 08 09 10 11 12 13 14
I used a mg_cfg i found off the net as i didn't receive one.
Im guessing this is where the issue lies. Can anyone advise on how i set this up?
Thanks in advance
I have set up my zgemma H.2S with the great Kidda Setup guide. I have all of it working apart from my Nline. I installed MGCamd-1.38 with the instructions in the guide but cannot see the channels. BBC1 etc are fine
I only received a line of copy for the line. e.g CWS =(Deleted copy) 01 02 03 04 05 06 07 08 09 10 11 12 13 14
I put it into the newcamd.list file as follows;
CWS_KEEPALIVE = 300
CWS_INCOMING_PORT = 21000
CWS = (Deleted copy) 01 02 03 04 05 06 07 08 09 10 11 12 13 14
I used a mg_cfg i found off the net as i didn't receive one.
Im guessing this is where the issue lies. Can anyone advise on how i set this up?
Thanks in advance