Cable Zgemma H1 full VM Setup guide
- Thread starter TeesMaarKhan
- Start date
c4rp3tburn
Newbie
Thanks for this step by step gude mate everything went well all the way to the end ....i got a test line to try it out but channels wont clear
i dont know where i went wrogn if i did go wrong.
I have FTA showing but nothing else any help would be fantastic
Success all working now i think the problem was i overwrit the newcamd.list instead of editing the file in the image
thx for the help and guide
i dont know where i went wrogn if i did go wrong.
I have FTA showing but nothing else any help would be fantastic
Success all working now i think the problem was i overwrit the newcamd.list instead of editing the file in the image
thx for the help and guide
Last edited:
Hi All, Getting my Zgemma H1 Combo in the next few days and will follow the instructions given here and hopefully I'll get it sorted but the only thing I am stuck on is how to get a line and where? Can someone please pm me info on this as I'm rather new to this scene and could do with a little help. Thanks in advance!
Archiethere
Newbie
Hi, first of all thanks a lot for the guide, it's been a massive help. I've done all steps up to where it says step 31 "you should only have rytec Virgin media in there" .. Mine says sky. I also only have a few free view channels when I switch the box on, I did a full scan, it came up with 400+ channels but none of the cable ones worked and the channels was all over the place. Could someone please tell me where I'm going wrong?
I'm having the same issue with mine with only a small list of channels being available however when I press the EPG button and go to the last scanned folder it shows all the channels and they all work. They are however in no order whatsoever and not available under any of the other tabs, does anyone know how I can sort this?
Many thanks for this great post I've learnt from your post well done. As a newbie can I please ask a couple of questions as I need help?
As I have a Sky in 1 room and VM in another can I set the box up with either a Sky cable or my VM cable to cover both tuners?
I managed to set the box up on Sky and working with my N.line but I can't get VM setup any advise or help would be much appreciated
As I have a Sky in 1 room and VM in another can I set the box up with either a Sky cable or my VM cable to cover both tuners?
I managed to set the box up on Sky and working with my N.line but I can't get VM setup any advise or help would be much appreciated
Marcus_2001
Newbie
As you said, it wasn't complete but without you I wouldn't have even got to FTA, so thank you, much appreciated. Regards, Marcus. x x x
superman60
Newbie
Hi
I've just got my new h1 and I've followed flashing instruction exactly using sandisk 16gb usb (formatted to fat32) but when I power up box I get "boot" then it just counts up from 00-99 continually. Obviously its not flashing do I just need to keep trying different sticks?
Thanks in advance.
I've just got my new h1 and I've followed flashing instruction exactly using sandisk 16gb usb (formatted to fat32) but when I power up box I get "boot" then it just counts up from 00-99 continually. Obviously its not flashing do I just need to keep trying different sticks?
Thanks in advance.
Archiethere
Newbie
I had the same issue at first, have you copied over the full folders to the USB? Not just the sub folders? Mine wouldn't flash till I copied all folders over
worked 1st time no problems thanx again matey
anyone know how to install the red skin cant get used to sky one, i know its the image i need but not sure which it is
garyth
TK Veteran
should be in skins or get the skin via plugin, vm red I believe is the one your looking for!
thanx matey u got link cant find plugins section
