Did you just install it over woosh or did you have to reflash a base arc?I had same problem went round in circles for 2 days so installed grogbuild free-range via putty went on seamlessly. All is well now
Hi I have infinity on my box and downloaded softcams 4.3 but it’s not working the cams don’t seem to work is this install something different as I don’t remember that commandTo get infinity on your box you reflash with open atv6.2 then when it gets to hdmi setting type this command into putty or webwif opkg install http://wbuildx.co.uk/setup.ipk then press enter
I did both started off with wooshbuild so did inline update then tried again from scratch. Dsayers helped as much as he could yesterday but to no avail so I just went with grogbuild until woosh has a look at the feedsDid you just install it over woosh or did you have to reflash a base arc?
Thats to put infinity onto your box mate I use vix and willobuild softcam working on there use infinity on my iptv box so can't say about softcam feedsHi I have infinity on my box and downloaded softcams 4.3 but it’s not working the cams don’t seem to work is this install something different as I don’t remember that command
Thanks for reply, sorry for all questions I’m a bit of a novice at this, when I put atv 6.2 on there was no cam feeds so if II did both started off with wooshbuild so did inline update then tried again from scratch. Dsayers helped as much as he could yesterday but to no avail so I just went with grogbuild until woosh has a look at the feeds
hi sorry for all questions I’m a novice at this when I put openatv 6.2 I noticed it had no cams in it so would I not run into same problems with grogsbuild (I really am a novice)I did both started off with wooshbuild so did inline update then tried again from scratch. Dsayers helped as much as he could yesterday but to no avail so I just went with grogbuild until woosh has a look at the feeds
I didn't I think the problem lies somewhere in infinity softcam feeds not with grogbuild as they are two different buildsThanks for reply, sorry for all questions I’m a bit of a novice at this, when I put atv 6.2 on there was no cam feeds so if I
hi sorry for all questions I’m a novice at this when I put openatv 6.2 I noticed it had no cams in it so would I not run into same problems with grogsbuild (I really am a novice)
Ok so do I need to put it back to basics by putting atv6.2 on first then grogsbuild? , or just put grogs over woosh?just trying to get it clear in my head and is grogsbuild on here somewhereI didn't I think the problem lies somewhere in infinity softcam feeds not with grogbuild as they are two different builds