best build for h2s

[Beasty007]

at the minute im using ipab image/build but disliking it
my question is whats the best image to use

 

[sn0wman1]

There are 2 in the stickies at top of this forum. One is openatv and one is openvix. Openatv is officially supported where as openvix is a patched version of vix which is not. So shouldnt be updated online.Install any they are both good in their own right. Have a play about with it and get used to how everything works then you could have a go at building your own image using kiddacs barebones tutorial. Hope this helps

 

[Beasty007]

just tried to reflash with whooshbuild but goes from boot to loading channels on ipab yes i did deep reformat on usb and coppied the correctfolder over but if i use same usb even after reformating it flash with ipab image or build

 

[sn0wman1]

Are you only putting the zgemma folder on stick?. If yes check inside that folder and then in the h3 folder and see if there is a file called force. If it says noforce change it to force. Also make sure there is no other drive connected

 

[Beasty007]

i checked says force and yes i know about no other usb inserted

---------- Post Merged at 10:11 PM ----------

just checked it says sh1 folder for some reason not h3 folder

 

[sn0wman1]

You are flashing the wrong firmware. I believe that's for 2s not h.2s

---------- Post Merged at 10:21 PM ----------

Get it from here
http://www.techkings.org/zgemma-sta...-transfer-plugin-basebuild-openatv-5-1-a.html