grahamer67
TK Veteran
Should be 5, with softcam set up being the first one. Reflash grogbuild should fix it.
Last edited:
Sorry! Red button brings up "Info Panel" menu with four options "Software Manager" "Keymap Selection" "Plugins" and "Infos" And going into them individually still does not show Softcam setup
You have no softcams installed.
Which means you have probably flashed plain openatv and not grogbuild freerange
Using Putty, I followed full Grog FR instructions and it took me right to the end succefully, details show V6,4 is loaded.You have no softcams installed.
Which means you have probably flashed plain openatv and not grogbuild freerange
Nope! Just blank screen when the spinning stops. Going into tuner configration, it scanned the Chanel list successfully though
Thx mate! I did that twice today but cant make any headway. same problem. May be I should be trying an earlier versionReflash grogbuild and thats you sorted
Thats a good suggestion, I shall try that in the morning. ThxTry using filezilla to flash, by just following the grogbuild installation thread in resources.
Thx mate! I did that twice today but cant make any headway. same problem. May be I should be trying an earlier version
Thx. I did that exactly using putty route and filled in the correct details as askedIf you initialise a usb in the box, then paste grog command line in, the box flashes todays openatv6.4 and puts grogbuild on.
You don't flash it manually, the box does everything for you
Thx. I did that exactly using putty route and filled in the correct details as asked
Ok! I shall try this too. ThxGrogbuild didn't flash
You don't need putty, just use webif/terminal
make sure the usb is initialised before you begin
Now I remember why I used Putty as there was no "Terminal" in the webif menu. I think I have to install that first as it is still not showing in the Webif details.Sorry mate, I had said filezilla, dunno what I was thinking, meant webif, pablos correct, just follow the guide step by step, it is straight forward.
I am scratching my head now as I have loaded via Putty at least three times thinking may be I made a mistake previously and successfully comleting the procedure till the end but failing to find the elusive "softcam" menu.Strange, but try putty again then as something may have gone wrong the last time.
Thx. Will do in the morning nowon the remote, press green, twice, choose extensions, scroll down to terminal and install it.
When you openwebif, Terminal is there