Yes.
ZGEMMA H9 TWIN cannot update openATV or flash new version
- Thread starter okthought
- Start date
Ok. Thanks for your help will go get another usb now. I have been using 2 usb though. Will go get another one.
Ok. Thanks for your help will go get another usb now. I have been using 2 usb though. Will go get another one
You need to put your finger on the standby button when you power it on.
When it says FLASH keep finger on for another 5 seconds or so then take it off
When it says FLASH keep finger on for another 5 seconds or so then take it off
bigwig21
Member
And also hold in the small black button by the HDMI port.
moshibeth
TK Veteran
Only use a sandisk
Ok. Thanks for your help will go get another usb now. I have been using 2 usb though. Will go get
Ha! I buy a Kingston usb. Hope its ok?
moshibeth
TK Veteran
That should be fine
Its doesn't have a standby button. Only got black reset button at the back. Its a H9 Twin box
Ok thanks. Will try it again.
bigwig21
Member
He means the white power button on the back and the small black reset on the back.
hold both in and then release as in the video.
Still same old story with the new usb. Stuck on red light boot.
bigwig21
Member
Do you have all these files on your usb?
sorry for the quality but took a screenshot from video.
Attachments
Yes please
moshibeth
TK Veteran
Not with a new usb just out of the box
Im unable to open the file.
celticfc
TK Veteran
opens ok for me winrar
bigwig21
Member
For DAMMY
Quick update from yesterday,h9 twin
i did a software update this morning on openatv6.4/woosh and the box got stuck on boot with red light on.
i downloaded the latest 6.4 files and put on usb,removed hdd at back and put usb file in front slot and held white and black button and flsh came up and then to boot with red light,30 secs later the boot menu appeared so i moved to partition 1 where my origjnal build was and pressed ok to boot but went back to red light again.
i then did it again with usb in front flsh until the boot menu showed then clicked on partion 2 where 6.3 was and clicked on that and it booted up ok.
i then flashed 6.4 from the flash online on 6.3 partion 2 to partion 1 and when flashed restored settings.
if you only have one partion used you will have to use bootmenu/ok/flashlocalimage[openatv etc on usb] and flash from scratch.
the update must have corrupted the image on partion 1and could not be recovered.
hope this makes sense and helps.
Quick update from yesterday,h9 twin
i did a software update this morning on openatv6.4/woosh and the box got stuck on boot with red light on.
i downloaded the latest 6.4 files and put on usb,removed hdd at back and put usb file in front slot and held white and black button and flsh came up and then to boot with red light,30 secs later the boot menu appeared so i moved to partition 1 where my origjnal build was and pressed ok to boot but went back to red light again.
i then did it again with usb in front flsh until the boot menu showed then clicked on partion 2 where 6.3 was and clicked on that and it booted up ok.
i then flashed 6.4 from the flash online on 6.3 partion 2 to partion 1 and when flashed restored settings.
if you only have one partion used you will have to use bootmenu/ok/flashlocalimage[openatv etc on usb] and flash from scratch.
the update must have corrupted the image on partion 1and could not be recovered.
hope this makes sense and helps.