the 'line installer' file in the put your line on box folder
the 'line installer' file in the put your line on box folder
the 'line installer' file in the put your line on box folder
the error shouldn't affect the line. i had the same problem but could still out the line on box. had all channels working just couldn't use timeshift (pause, rewind, record)
did you get the same info from the line installer as whats shown in woosh's pic?
U can run ur CCcam.cfg on these no probs when u first get it. Then worry about perfect way later.
you'll need an ftp program on pc to send over ur router to the box. I find dreambox control centre best. SSimple with steps
Google dreambox control centre.
download to pc and install.
open it.
middle right of screen click search
new window click search
wait untill u c ur box ip address is found
dbl click the ip address of box
window disappears
click reconnect
should say telnet, ftp, enigma 2 connected
bottom left click ftp
opens window.
left pane is box
right pane is pc.
find ur CCcam.cfg in right panel wherever on ur pc.
dbl click etc folder in left pane
single click ur CCcam.cfg in right pane
click arrow in middle pointing left
yes to replace
The rest depends on what box software image u want to run. But loads of people here to help
no, just trying to rule things out
---------- Post Merged at 02:19 AM ----------
found this by sucmnsee. I've exhausted my knowledge again lol you could give this a try if you're feeling nocturnal.
other than that it looks like you'll have to hold out for tomorrow when Woosh comes online
U can run ur CCcam.cfg on these no probs when u first get it. Then worry about perfect way later.
you'll need an ftp program on pc to send over ur router to the box. I find dreambox control centre best. SSimple with steps
Google dreambox control centre.
download to pc and install.
open it.
middle right of screen click search
new window click search
wait untill u c ur box ip address is found
dbl click the ip address of box
window disappears
click reconnect
should say telnet, ftp, enigma 2 connected
bottom left click ftp
opens window.
left pane is box
right pane is pc.
find ur CCcam.cfg in right panel wherever on ur pc.
dbl click etc folder in left pane
single click ur CCcam.cfg in right pane
click arrow in middle pointing left
yes to replace
The rest depends on what box software image u want to run. But loads of people here to help
---------- Post Merged at 02:21 AM ----------
Not sure that will be much use as by the looks of it the line is on the box just not working. I think woosh will probably test the line himself for you. It's sounding like an issue with that but i can't be sure
unfortunately that's what i'm thinking. But let's be optimistic and hope that's not the case, however it could also be something really stupid and small that you've missed or changed. fingers crossed!!