pabloescaban
VIP Member
After dropping it in tmp folderyeah, got it earlier. not using vix, open atv
Press portal button
8 software management
Ipkg install
After dropping it in tmp folderyeah, got it earlier. not using vix, open atv
atv lover youAfter dropping it in tmp folder
Press portal button
8 software management
Ipkg install
Once it's installed, the softcam you want will be in the softcam feedsGot that bit done ok earlier, but its the next bit that I got stuck on
When using oscam are you using two different lines or just one?Average ecm time (200 ms)
On all channels
if you go to oscam setup \info show log it will give you correct oscan version detailsWhere can I download oscam emu 11667 ipk from please?
mine is showing 1.20+git1926 currently
if you go to oscam setup \info show log it will give you correct oscan version details
Use the latest version of oscam and should be listed in feedsOk so I've pressed red button > softcam-setup and showing oscam-emu
clicked on blue button (info) then show log and I get error: oscam webif disabled
if i try go to port :83 on my box ip nothing loads either?
oscam stable is showing 1,20_svn build r11581 however
Use the latest version of oscam and should be listed in feeds
Don't tell him Pike!Managed to get Oscam Version 1.20_svn build r11667-798 installed now thanks to @linesman66
How do I now add my existing mgcamd line into oscam please?
No problem just thought I’d check.The oscam on the "feeds" only gets updated when an image build is run.
Openvix 5.4 001 was run over 3 weeks ago. OpenATV run almost daily builds.
Hi mate any chance you could point me in the right direction as I can't find this version of oscam either. ThanksManaged to get Oscam Version 1.20_svn build r11667-798 installed now thanks to @linesman66
How do I now add my existing mgcamd line into oscam please?
Hi mate where can I download the ipk file for this version of oscam I can't seem to find it anywhere. Thanksyeah, got it earlier. not using vix, open atv