Flashing stuck between usb and update!

Regrim

Registered
Zgemma h2s was stuck on boot, tried flashing with new infinity image!
Now alternating between usb and update
Any ideas please or which image can I try?
 

bazcfc1

TK Veteran
Forum Supporter
For infinity you reflash with open atv then when it gets to hdmi setting on open atv put the remote down open putty type your box ip address in then press connect will say login as type root press enter then enter the command to install infinity opkg install http://wbuildx.co.uk/setup.ipk
 

[email protected]

TK Veteran
Forum Supporter
'UPDT' - I reckon you don't have an image on your usb but some sort of settings backup.

Are you restoring from a back up? if so, did you do backup image or backup settings when you created the backup?
 

Willo3092

TK Veteran
Forum Supporter
The display will show USB/UPDT if there is a noforce file on the flash drive on mipsel receivers.
You can just press the power button or change noforce to force.
 

Regrim

Registered
'UPDT' - I reckon you don't have an image on your usb but some sort of settings backup.

Are you restoring from a back up? if so, did you do backup image or backup settings when you created the backup?
Was stuck on boot after power cut does anyone have copy of firmware to get going again pl5
 

Willo3092

TK Veteran
Forum Supporter
Any firmware should flash the box. What happens after you flash and remove the usb stick, is it still stuck on boot?
 

Willo3092

TK Veteran
Forum Supporter
I thought you'd already flashed it and it just won't boot?
If that's the case my money is on the PSU.
 
Top