WooshBuild Initialise USB on Startup

Sir Osis

Member
Just reflashed H2S with Woosh over 6.4 and have usb set up properly but every time I start the box it tries to go through the initialisation process.
Any ideas lads?
 
Skip initialize USB then initialize after setup if needed. If the storage device has already been initialized before no need to do it again
 
Just reflashed my box and it all installed as expected

You go through the video wizard, through the tuner config, through the network wizard
You then start the WB installation. You select no on initalising USB
Does it get to the end of the setup i.e run a channel scan and alter screen position?
 
Yes,does all of the above.
Im using infinity since it came out and have flashed numerous boxes but never had this.
 
All installed as it should, I restarted the box a couple of times and all was ok.
I can do you a complete backup if that helps
 
Thanks for the file Makido.
Unfortunately still has the set up screen on start up.
Works as it should when I press exit,not a big deal.
 
I dont honestly know what else to try the backup I made you was working perfectly on my box.
When I restarted the box a few times it brought me back to BBC1. Which is what it is meant to do.
Very strange....

What happens if you setup as IPTV only and setup your tuners etc manually
 
Sorted.
Set up the box with tuner configured and it worked.
Boots up as normal,setting up for iptv only seemed to be the issue.
Thanks lads.
 
Back
Top