I was connected via a VPN set to a non European server both in the run up to and during the message and block occuring and I've since tried servers located in other Countries and even a different VPN service but no change.I'm out at the moment, have you tried disconnecting your router to renew the IP address and try your Mag after? Obviously check the ip before/after so it has changed.
I have the same problem on my MAG254. Can anyone post an earlier version of firmware than 0.2.18-r23-254 please. Many thanksIt's to do with new software from informir, any server that's been flagged up will be blocked by your mag boxes,
Try going back at least 2 or 3 software versions see if this cures problem.
http://soft.infomir.com/mag256/release/2.20.05/I have that warning message, I woke up to it this morning on my mag256.
It's stuck on the portal selection page.
I have another provider that works fine.
Only happening on a certain provider.
It will not allow me to load the certain provider.
I think it must have updated the firmware overnight.
Liking for older firmware.
Hihave you asked your provider if your firmware version is enabled on their servers?
No thought it best not to ask Sly anything regarding a mag box with my sip provider
I have mentioned that another provider works fine, so I don't know if the url has been flagged up.on Sly sip?Isp provider