dsayers2014
VIP Member
Did you try the command line as posted in here? OpenATV Softcam Feed
Code:
wget -O - -q http://updates.mynonpublic.com/oea/feed | bash
wget -O - -q http://updates.mynonpublic.com/oea/feed | bash
Did you try the command line as posted in here? OpenATV Softcam Feed
Code:wget -O - -q http://updates.mynonpublic.com/oea/feed | bash
Not tried this friend.
When you have time if you don't mind can you explain where to add it please?
No hurry as I'm out at min. Thank you.
Hi i have done this and i have added the only mgcamd that was available. I have no idea what version this is as when i go into cam set up it just shows as mgcamd .Is this the latest version? is there anyway to see what it is as i cannot get my lines working.Installed in usr ,keys in a newcad.list but not working? Thanks.You can copy and paste it in openwebif, terminal the same way you used the command line for wooshbuild infinity.
Once installed reboot box goto plugins green to download plugins, softcams download your cam and reboot again.
After you have installed cam and rebooted Menu > Setup > Decryption and Parental control > Softcam Setup
Yes I have done that . Thanks.Have you transferred an mg_cfg file to usr/keys?
OpenAtv 6.3 just been downloaded and installed.wooshbuild infinity!What is the date of the image you are using? Better still take a screenshot of the information page and upload it here.
Menu > Information > About
Thanks.OpenAtv 6.3 just been downloaded and installed.wooshbuild infinity!
The image date is important. Did you download an old one that was uploaded some time ago or a new one directly from OpenATV server
What is the date of the image you are using? Better still take a screenshot of the information page and upload it here.
Menu > Information > About
Thanks.
Not sure what you mean by out put but attached is what happened then rebooted but all still the same? The mgcamd is showing in cam set up.lines are in usr,keys in Newcamd.list , mg_cfg is in usr, keys,still not working? Thanks.Issue the following commands and post back the output. Please don't just say you did it.
wget -O - -q http://updates.mynonpublic.com/oea/feed | bash
opkg update
opkg --force-reinstall install enigma2-plugin-softcams-mgcamd
ThanksThanks.
Ok be great thank you. How private message and is all you need IP? ThanksThere's a mistake in your newcamd.list or in your other configs, if you want me to login and check send me a PM, it'll take me 5 mins.
Bear in mind I'm going out in half hour though
Ok be great thank you. How private message and is all you need IP? Thanks