Yes I extracted the file onto USB.Okay i can see box is flashing and usb is flashing which is good but not seen the box reboot after you flashed the file.
Was that the recovery file you downloaded and extracted to usb stick.
Maybe try the front port just to see that it is the same.
Not sure if these boxes also suffer from power issues as many need new supplies and box can work again?
Not sure what you think a power issue entails but it simply means to try a different PSU, you said earlier you have a H9? Use the PSU off that on the H7 and see if it boots after flashing.Yes I extracted the file onto USB.
There is no front port. Only rears. Tried all.
If it's a power issue then forget trying to get it fixed. I think it's three years old so out of warranty.
Need to find a cheap alternative now. Just a headache
Any 12v PSU can be used, providing the jack plug fits into the device, check the watts, ideally you want a higher wattage than the H7 but even if it's the same it will still work if it is the H7 PSU is faultyOh right sorry I didn't know you meant power from the socket.
Is it safe to use the h9 power on the h7. If so I can try that.
Waiting for confirmation
Erm latest vix possible on the websiteI'll fetch a H7 out of the loft in a bit and have a go at flashing it.
Are you flashing ViX 6.2 or 6.3?
Yh tried all ports.There are 2 usb ports in rear did you try the other one
+ try to see if you have another power supply to check , yes psu go fautly and not enough power to get box working
Hmm if I have to purchase another receiver I'll think I have to avoid zgemma.If you don't need the additional tunner DVB-S2
The H9 twin is back in stock
Erm.I haven't tried it yet but have you tried flashing the version prior to the latest?
Link here: https://www.openvix.co.uk/openvix-builds/zgemmah7/openvix-6.2.010.release-zgemmah7_recovery_emmc.zip
Ok followed your steps from start to finish still didnt work.I haven't tried it yet but have you tried flashing the version prior to the latest?
Link here: https://www.openvix.co.uk/openvix-builds/zgemmah7/openvix-6.2.010.release-zgemmah7_recovery_emmc.zip
Oh sorry I didn't look. I just moved the plug and powered on.On the H7 PSU what is the wattage?
Likewise the h9 PSU?