Satellite Zgemma h7s stuck on boot
- Thread starter joysleep1
- Start date
This is the design of the duo 4k psu which still didn't work.
The issue is the unit itself
Nice one. So after you flash do you see numbers climbing straight away right?
Willo3092
VIP Member
Vu+ buy cheap Chinese PSU's the same as everyone else.
If the PSU plugs directly into the wall it's a cheap one. Get one of those with a lead that plugs into the socket and another lead to the box.
This is the case. It's separated. It's definitely a good psu.
Last thing I'll do is try my ultimo 4k psu but again I can't see it making any difference
Willo3092
VIP Member
Yes. It's working flawlessly.
The only issue I had from a clean boot was that samba wouldn't install and I had to do it from putty.
Worked fine from a settings backup.
So you're not actually using the psu that came in your box?
moshibeth
TK Veteran
Are you a glazier by trade willo 🤣
Willo3092
VIP Member
Absolutely not! I use 12v 5a PSU's on all my boxes. These are the ones I bought 5 years ago but they were only £9 each then.
https://www.amazon.co.uk/gp/product/B00OGQMH50/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
Oh right fair enough. I thought the ones you get with the receiver should be good enough.
bigwig21
Member
Have you tried this....
Turn box off,white button pressed out.
Now point your remote at the box holding down the red power button.
Now press the white button on so the box starts but keep remote power button pressed.
Release red power button when you see rcy on front display.
This will now load recovery menu.wait 30 secs or so.
When recovery menu appears,scroll down to bootmenu.ok
scroll to flash online image,ok
Choose which image you want,ok
let it download and it will ask what partition you want to use.
Then it will flash,
If using openatv 6.4 or higher,
Fully flash then set password ,menu,setup,system,network,password setup,ok,set password green button to save.
you can then use command prompt for builds.
Hope this helps👍
Turn box off,white button pressed out.
Now point your remote at the box holding down the red power button.
Now press the white button on so the box starts but keep remote power button pressed.
Release red power button when you see rcy on front display.
This will now load recovery menu.wait 30 secs or so.
When recovery menu appears,scroll down to bootmenu.ok
scroll to flash online image,ok
Choose which image you want,ok
let it download and it will ask what partition you want to use.
Then it will flash,
If using openatv 6.4 or higher,
Fully flash then set password ,menu,setup,system,network,password setup,ok,set password green button to save.
you can then use command prompt for builds.
Hope this helps👍
Willo3092
VIP Member
He's using a H7, there's no recovery menu.
So I did this recently with my zgemma h9 twin. I'll try it after the match on my h7 but I think this remote feature is only applicable to h9.
moshibeth
TK Veteran
Should have gone to Specsavers 🤣
Yh I tried that multiple times