Grogbuild Free Range - now cant access Filezilla

Dykey

Registered
Have installed Grogbuild Free Range on an H2H but for some reason now it wont connect to Filezilla to add my line details - any ideas why this might be ?

TIA

Dykey
 

grog68

VIP Member
Forum Supporter
With ATV 6.4 a password needs to be set, Menu -> Setup -> System -> Network -> Password setup
 

ronnierobson123

Registered
iv had the same problem got it sorted by changing pass but now i done all that got it working but problem is when flashing it again have to put open atv 6.4 back on from fresh cant use grogs bulid it asked for pass but dose not accept it just hat reflash back form fresh
 

grog68

VIP Member
Forum Supporter
iv had the same problem got it sorted by changing pass but now i done all that got it working but problem is when flashing it again have to put open atv 6.4 back on from fresh cant use grogs bulid it asked for pass but dose not accept it just hat reflash back form fresh
are you resetting password after flashing?
 

grog68

VIP Member
Forum Supporter
you use password to log in to box via putty or terminal and then run the grogbuild code, once reflashed and grogbuild is on box you just reset the password. I've not reflashed a box with 6.4 already on it yet, but can't see why it wouldn't work
 
Top